How To: Make Shipping Cost Depend on Order Total and Weight

To set up a shipping cost that depends on order total and weight:

  1. In the Administration panel, go to Administration → Shipping & taxes → Shipping methods.

  2. Create a new shipping method with manual rate calculation or click on the name of an existing one.

  3. The shipping method editing page will open. Switch to the Shipping time and rates tab.

  4. Select the rate area for which you’d like to configure the shipping cost. If you don’t see the choice of rate areas, it means that you only have one.

  5. Configure the Cost dependencies section as follows:

    Products cost Rate value Type
    More than $0.00 25 Absolute ($)
    More than $50.00 20 Absolute ($)

    Hint

    To add more rates, click the + icon on the right; it appears when you hover a mouse pointer over an existing rate.

  6. Configure the Weight dependencies section as follows:

    Products weight Rate value Type
    More than 0 lbs 2 Absolute ($)
    More than 100 lbs 3 Absolute ($)

    Note

    Make sure to specify the weight when you add or edit products.

  7. Click Save (or Create, if you’re adding a new shipping method).

    In this case the shipping rates from the Cost dependencies and Weight dependencies sections will apply together. Here are some examples of how the shipping cost will be calculated:

    • The order total is below $50, and the order weight is less than 100 lbs: $25 + $2.
    • The order total is below $50, and the order weight exceeds 100 lbs: $25 + $3.
    • The order total exceeds $50, and the order weight is less than 100 lbs: $20 + $2.
    • The order total exceeds $50, and the order weight exceeds 100 lbs: $20 + $3.